How to delete a file saved on levels

[Stephen Liu]

(07-18-2022, 08:42 AM)Ofnuts Wrote:

(07-18-2022, 05:34 AM)Stephen Liu Wrote:

(07-17-2022, 03:23 PM)Ofnuts Wrote:

• Whatever it to the left of the left handle in the Input is converted to the value of the left handle in Output
  
• Whatever it to the right of the right handle in the Input is converted to the value of the right handle in Output
  
• Values between the two left/right handles in Input are stretched/squished to fit between the values of the handle in Output
  
• The middle handle in Input more or less says what value will end up mid-way in the output.
  

For photography, you usually do not touch the output handles because you want your image to have the maximum dynamic range from pure black to pure white.  So you drag the left handle to the right to set the "black point" (value below which everything should be pure black) and the right handle to the left to set the white point (value above which everything should be white). This stretches the available range for other tones in the image.

For instance this picture has no black and no white and could be considered as "flat":

I drag the black and white handles to where the histogram really begins

In the final image, the darkest pixels are now black and the lightest are white

Lot of thanks for your detail advice.

My problem is that the 3 small triangles under the Input and Output slides are invisible on the screen.  I suppose that I can use the number boxes "[0]" and "[255]" at both ends.  What about the middle small triangle?

I'll connect 24" 2K display to check later.

Regards

The middle handle acts on the middle number entry widget (and vice-versa).

Thanks.  I'll test it later.

Performed following test;

GIMP 2.10

tried it on my spare PC

24" Dell display

Resolution:-
2560x1440
1920x1080i

Colors -> Levels
Adjust Color levels
3 small triangle handlers are not displayed.

I think the only solution is going back to GIMP 2.8

Regards