Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Making images with 300 dpi
#8
from librecad the drawing size produced is far bigger than I need (thousand by thousand or more. I have at most 700 pixel wide space in my pages. But the jpg librecad exports is few thousand . So it is ok. I am just reducing the size of images to 700 pixel wide at most. But form my previous experience with amazon, if the dpi of a picture in pdf file was below 300, it gave error automatically and I remember going back and adjusting the dpi of those images to 300 and it had worked. That is my concern. Otherwise I am not also fond of adjusting ppi of a couple hundred images from 96 dpi to 300. . That is the only reason I am doing this. Are you saying I do not need to?
Reply


Messages In This Thread
Making images with 300 dpi - by snowforest - 07-27-2021, 08:37 AM
RE: Making images with 300 dpi - by Ofnuts - 07-27-2021, 09:16 AM
RE: Making images with 300 dpi - by rich2005 - 07-27-2021, 09:25 AM
RE: Making images with 300 dpi - by snowforest - 07-27-2021, 11:58 AM
RE: Making images with 300 dpi - by rich2005 - 07-27-2021, 12:43 PM
RE: Making images with 300 dpi - by snowforest - 07-27-2021, 12:56 PM
RE: Making images with 300 dpi - by rich2005 - 07-27-2021, 01:23 PM
RE: Making images with 300 dpi - by snowforest - 07-27-2021, 01:31 PM
RE: Making images with 300 dpi - by rich2005 - 07-27-2021, 01:49 PM
RE: Making images with 300 dpi - by snowforest - 07-27-2021, 02:05 PM
RE: Making images with 300 dpi - by rich2005 - 07-27-2021, 02:24 PM
RE: Making images with 300 dpi - by snowforest - 07-28-2021, 11:37 AM
RE: Making images with 300 dpi - by rich2005 - 07-28-2021, 12:13 PM
RE: Making images with 300 dpi - by snowforest - 07-28-2021, 12:23 PM
RE: Making images with 300 dpi - by rich2005 - 07-28-2021, 12:36 PM
RE: Making images with 300 dpi - by snowforest - 07-28-2021, 12:46 PM

Forum Jump: