Remove selective cast/stain

[The_JinJ]

(06-29-2017, 06:01 PM)rich2005 Wrote:

(06-29-2017, 04:50 PM)The_JinJ Wrote: Good try that...I can't seem to get the filter to work - I have a B&W image as bottom layer and a colored top layer but not merging the two..... any ideas?

I tried wavelet decompose and tidied up the colour residual image with some success.

Not something I use very often, so I usually have to fiddle around with it.

Although it says B & W the image obviously has to be in RGB mode.
then it is set up like this: http://i.imgur.com/rLhrbI8.jpg - all layers - bottom (desaturated) layer active - output to a new file.

Thanks! I had the input layers set incorrectly, obvious mistake