Replicating a path

[Ottia Tuota]

(01-30-2022, 05:34 PM)denzjos Wrote:

(01-30-2022, 04:43 PM)Ottia Tuota Wrote:

(01-30-2022, 04:27 PM)denzjos Wrote: Ottia Tuota, nice job. I had the same problem setting the number of copies to zero, but I see that the plugin is updated. I tried the new version and now it is working ok. My example (set the length of the copies 30 for good result)

Nice picture. When I tried it I had to set 'no distortion' to get it to work. If I used distortion the plugin fell silent and my patience ran out before the plugin finished. Could be that it would finally have finished but the result would probably have been no good, the paths being so complicated.

The plugin uses my own approximation algorithm to make Bezier curves and I don't quite trust it. Better think this plugin as experimental.

I wish I could draw like that!

Well, I think the result is more than acceptable :

I see, one has just to wait long enough. This shows that the plugin could be faster, and perhaps I should trust it more. But there is one problem case: On the cat's head one disfigured mouse could be deleted. Perhaps that is a case of a too tight bend.