Thanks for the Reply. This is one file with Cockpit legends for many aircraft in DCS, IL2, MSFS, etc... Lot's of layers, but it works fine. Loads into gimp in 6 seconds.
Split & Erase were not even in the Layer Mode. But I noticed that the Layer Mode was set to Legacy. And the Mode was Normal(l). Could that cause this?
Hey, it's in Legacy mode now with Normal(l), and I just noticed that this happens when I press the caps Lock key. Each time I press it the selection changes by 1-2 pixels.
This text was 'BRT', and I typed sss. Then I backspaced and pressed cap lock(and it started selecting the text), and type SSS. Then backspaced to remove then SSS, this is what I ended up with.
EDIT:
This was strange, but I think that I found the problem.
In Keyboard Shortcuts, I found a command 'Add to Selection' that had a key called 'VoidSymbol' assigned to it. IDK what that is, but it didn't sound good, so I changed it to Disabled. Did the same tests, and now cap locks does not select any text anymore. Time will tell, but it seemed immediately fixed.
Split & Erase were not even in the Layer Mode. But I noticed that the Layer Mode was set to Legacy. And the Mode was Normal(l). Could that cause this?
Hey, it's in Legacy mode now with Normal(l), and I just noticed that this happens when I press the caps Lock key. Each time I press it the selection changes by 1-2 pixels.
This text was 'BRT', and I typed sss. Then I backspaced and pressed cap lock(and it started selecting the text), and type SSS. Then backspaced to remove then SSS, this is what I ended up with.
EDIT:
This was strange, but I think that I found the problem.
In Keyboard Shortcuts, I found a command 'Add to Selection' that had a key called 'VoidSymbol' assigned to it. IDK what that is, but it didn't sound good, so I changed it to Disabled. Did the same tests, and now cap locks does not select any text anymore. Time will tell, but it seemed immediately fixed.