To map a logo on a cylinder, you need two distortions, on that compresses the sides, and if the cylinder is not straight from the side (like your first image) , one that applies a bend.
Ideally, to do something realistic, you would use Filters > Map > Map object and map you logo to a cylinder. The very har part is figuring out the cylinder to map to...
If your logo is amenable to a path, there may be a much easier solution.
Ideally, to do something realistic, you would use Filters > Map > Map object and map you logo to a cylinder. The very har part is figuring out the cylinder to map to...
If your logo is amenable to a path, there may be a much easier solution.