+- Gimp-Forum.net (https://www.gimp-forum.net)
+-- Forum: GIMP (https://www.gimp-forum.net/Forum-GIMP)
+--- Forum: General questions (https://www.gimp-forum.net/Forum-General-questions)
+--- Thread: gimp curve bend (/Thread-gimp-curve-bend)
Pages:
1
2
RE: gimp curve bend - rich2005 - 12-12-2024
(12-12-2024, 08:56 AM)rita Wrote: for linux "22.04" and in my gimp there is only script-fu
And for map I will try it and see it
OK, that will be Ubuntu (or a spin off) Try an appimage, it will co-exist with your existing Gimp, so nothing is lost.
see: https://www.gimp-forum.net/Thread-new-gimp-2-10-38-appimages-with-python2?pid=40404#pid40404 which has info and a link to the download.
It is the one I use wih a kubuntu 22.04 laptop.
RE: gimp curve bend - rita - 12-12-2024
(12-12-2024, 09:20 AM)rich2005 Wrote:(12-12-2024, 08:56 AM)rita Wrote: for linux "22.04" and in my gimp there is only script-fu
And for map I will try it and see it
OK, that will be Ubuntu (or a spin off) Try an appimage, it will co-exist with your existing Gimp, so nothing is lost.
see: https://www.gimp-forum.net/Thread-new-gimp-2-10-38-appimages-with-python2?pid=40404#pid40404 which has info and a link to the download.
It is the one I use wih a kubuntu 22.04 laptop.
ok thank you I will check it
.I edited this post at the same time you wrote this comment. Could you please check it?
(12-12-2024, 09:19 AM)Ofnuts Wrote:(12-12-2024, 06:08 AM)rita Wrote: Let's say I want to place an image, like Pikachu, on a cylinder. When I tried, only half of the image was visible. Is there a specific width and height I should use to fit it properly on the cylinder?Or could there be another problem I caused?
Because the whole width of your layer is mapped to the 360° of the cylinder, so half of your image is wrapped behind the part that you see. You probably want your image to cover 90° to 120° of the cylinder, so your image should be surrounded by transparency in a layer 3-4x wider:
Ah, I see! I used the layer to image size, and it worked. Now the entire logo is visible.