Any Idea how to only select the background of the fence? Would like to make it transp - Printable Version +- Gimp-Forum.net (https://www.gimp-forum.net) +-- Forum: GIMP (https://www.gimp-forum.net/Forum-GIMP) +--- Forum: General questions (https://www.gimp-forum.net/Forum-General-questions) +--- Thread: Any Idea how to only select the background of the fence? Would like to make it transp (/Thread-Any-Idea-how-to-only-select-the-background-of-the-fence-Would-like-to-make-it-transp) |
Any Idea how to only select the background of the fence? Would like to make it transp - sargan26 - 08-28-2020 RE: Any Idea how to only select the background of the fence? Would like to make it transp - rich2005 - 08-29-2020 Bit of an unusual request, normally it is the grill to remove. A selection will be very difficult, a better way, perhaps, delete the whole area and recreate the grill. Might go like this. New layer, Filters -> Render -> Pattern -> Grid set spacing / size / colour / opacity to suit. screenshots: https://i.imgur.com/ffAoH3r.jpg Deform the grid layer to fit the image: Unified Transform is good for this but you could use Rotate then Perspective Transform. Not easy, take your time. https://i.imgur.com/O3ZoVV5.jpg Move the grid layer under. Add a layer mask Layer -> Mask -> Add layer Mask (white) Select area and fill in the layer mask. https://i.imgur.com/opoKUpY.jpg RE: Any Idea how to only select the background of the fence? Would like to make it transp - jappaloe1963 - 08-29-2020 https://www.youtube.com/watch?v=yBCj8Kg9lZg Try this! RE: Any Idea how to only select the background of the fence? Would like to make it transp - rich2005 - 08-29-2020 read the subject matter again Quote:Any Idea how to only select the background of the fence? Would like to make it transp Not the fence the background. |