+- Gimp-Forum.net (https://www.gimp-forum.net)
+-- Forum: GIMP (https://www.gimp-forum.net/Forum-GIMP)
+--- Forum: Extending the GIMP (https://www.gimp-forum.net/Forum-Extending-the-GIMP)
+--- Thread: Request for script - Guillotine + Watermark (/Thread-Request-for-script-Guillotine-Watermark)
Request for script - Guillotine + Watermark - sunslick - 09-05-2017
Hi everyone,
I perform a very repetitive task which I would like to automate.
I have a lot of PDF files, that I need to cut in pieces, watermark them (based on name of source file) and then save them back as PDF. For example
This is the source file called Sample.PDF (attached)
[attachment=735]
I insert 2 horizontal guides to divide the file in three areas (the guides are always horizontal). They location and number of the guides varies from file to file.
Then I use the Guillotine tool to split the file in 3 files. Each of these files have to be watermarked at the bottom as Sample_00, Sample_01, Sample_02 and saved as Sample_00.pdf, Sample_01.pdf and Sample_02.pdf respectively (attached).
[attachment=736]
[attachment=737]
[attachment=738]
I am not fussed about the naming format as long as it starts with the name of the source file and ends with a sequence number.
I have been trying to automate the following steps
1. Run Guillotine
2. Add watermark (format eg Sample_nn) near the middle bottom of the page generated by guillotine
3. Save files as Sample_nn.pdf in the same directory as the source file.
I am afraid I don't enough Scricpt-Fu or Pyton-Fu to be able to do it. Could any one of you assist please? Much appreciate your help !