Gimp-Forum.net › GIMP › General questions
Brush orientation

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Brush orientation
MCWSR Offline
Newbie
**
Posts: 3
Threads: 1
Joined: Sep 2019
Reputation: 0
Operating system(s):
  • Windows (Vista and later)

Gimp version: 2.10
#1
09-25-2019, 08:25 PM (This post was last modified: 09-25-2019, 08:25 PM by MCWSR.)
Greetings, just loaded 2.10.12 on a new laptop, windows 10 OS,  noticed right off that all my brushes are upside down.  To clarify the brushes look correct in the bush selection box however when I select a brush its 180, or upside down.  And that's true with every brush.  Any suggestions to correct this?

Thanks for any help with this
Mike
Find
Reply
Blighty Offline
Obsessive Gimper
***
Posts: 851
Threads: 11
Joined: Oct 2016
Reputation: 89
Operating system(s):
  • Windows (Vista and later)

Gimp version: 2.10
#2
09-26-2019, 04:28 AM
In the Tool Options make sure the angle is set to 0 (and not 180)


Attached Files Image(s)
   
Find
Reply
MCWSR Offline
Newbie
**
Posts: 3
Threads: 1
Joined: Sep 2019
Reputation: 0
Operating system(s):
  • Windows (Vista and later)

Gimp version: 2.10
#3
09-26-2019, 06:48 AM
(09-26-2019, 04:28 AM)Blighty Wrote: In the Tool Options make sure the angle is set to 0 (and not 180)

yea all the brushes are defaulted to 0, I have to set each one to 180 every time I use them to correct the angle.
Find
Reply
Ofnuts Offline
Administrator
*****
Posts: 6,340
Threads: 272
Joined: Oct 2016
Reputation: 563
Operating system(s):
  • Linux

Gimp version: 2.10
#4
09-26-2019, 07:22 AM
Make sure the "Dynamics" is set to "Dynamics off". There are "dynamics" that rotate the brush, and since the range is 0-360, the "neutral" position is 180° (upside-down).
Find
Reply
MCWSR Offline
Newbie
**
Posts: 3
Threads: 1
Joined: Sep 2019
Reputation: 0
Operating system(s):
  • Windows (Vista and later)

Gimp version: 2.10
#5
09-26-2019, 03:03 PM
(09-26-2019, 07:22 AM)Ofnuts Wrote: Make sure the "Dynamics" is set to "Dynamics off". There are "dynamics" that rotate the brush, and since the range is 0-360, the "neutral" position is 180° (upside-down).

Thank you very much, that corrected the issue with the orientation of the brushes, the dynamics were set to basic and changing them to dynamics off solved the issue.

Thanks again!!!
Find
Reply


Forum Jump: