05-06-2019, 08:39 PM
(This post was last modified: 05-06-2019, 10:08 PM by CruelHellCry.)
I have a photo that I need to put the ripple effect only in the bottom third of the photo. I imported the photo into GIMP 2.10.10 and then created an additional layer with the part that I wanted to put the ripple effect. While I was able to apply the ripple effect on the section, it created the ripple layers in a new tab.
I know that there is a way to do this, but I haven't been able to figure it out or find something thru Google.
Thanks!
Update 1:
The Waves filter works as expected in that the wave layers are in the same tab.
Update 2:
I copied the ripple layers from the new tab back into the original tab and I can get the ripple effect. But I know that something is not correct as I should not have to do this in order to have a ripple effect on the photo.
I know that there is a way to do this, but I haven't been able to figure it out or find something thru Google.
Thanks!
Update 1:
The Waves filter works as expected in that the wave layers are in the same tab.
Update 2:
I copied the ripple layers from the new tab back into the original tab and I can get the ripple effect. But I know that something is not correct as I should not have to do this in order to have a ripple effect on the photo.