Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Procedure Entry Point Error
#8
(04-09-2017, 08:45 PM)Ofnuts Wrote:
(04-09-2017, 07:45 PM)gazza Wrote: Hi 
Many thanks for you replies. However, I have carried out all of the suggested steps, and still no luck. The only change that I can think of that has happened in the last few days is the updating of my TREND antivirus software. Having said that, I have used TREND for about 5 or 6 years and never had a problem with GIMP. 

As well as following your instructions, I physically deleted the Gimp 2.8 and Gimp 2.8 backup up folders. Turned off my TREND and reinstalled 2.8.16 which was the last version that has worked well for ages. I also put an webb address exception into my TREND. None of this has worked, and when I go to open GIMP, I have at least 7 or 8 exception errors to wade through.

I am using Windows 10 (Proper paid version)

Any suggestions from here? It has become frustrating because I have been using my GIMP to rejuvenate about 300 off 35mm slides from our families collection and converting them to .jpeg, but this has made it a bit of a chore.

Regards
Gary

Windows10 updates itself very regularly (even if you tell it not to...). So you are positive that you couldn't find icui18n56.dll anywhere on your disk?

No .... the only reference I saw using Windows Explorer was when I searched using a few different search options (see attachment). There was definitely nothing on the C:\ drive.

Hi Ofnuts
Well, when I tried to use the Sharma version it turned out to be a disaster so I had to uninstall it. It looked good when loaded, but nothing worked. 
I reinstalled 2.8.16, and have to go thru the same exercise of clicking the exception errors.
However, when I searched for the "ICUI" file as you can see by my new attachment, there is only one in the C Drive and it belongs to GIMP.
So I am back where I started. Can use GIMP, but it is not without the same hassles.
Regards
Gary
Reply


Messages In This Thread
Procedure Entry Point Error - by gazza - 04-09-2017, 04:06 AM
RE: Procedure Entry Point Error - by rich2005 - 04-09-2017, 07:44 AM
RE: Procedure Entry Point Error - by Ofnuts - 04-09-2017, 10:54 AM
RE: Procedure Entry Point Error - by gazza - 04-09-2017, 07:45 PM
RE: Procedure Entry Point Error - by Ofnuts - 04-09-2017, 08:45 PM
RE: Procedure Entry Point Error - by gazza - 04-10-2017, 01:09 AM
RE: Procedure Entry Point Error - by rich2005 - 04-09-2017, 08:06 PM
RE: Procedure Entry Point Error - by gazza - 04-09-2017, 08:42 PM
RE: Procedure Entry Point Error - by gazza - 04-10-2017, 02:47 AM
RE: Procedure Entry Point Error - by gazza - 04-10-2017, 04:18 AM

Forum Jump: