06-07-2020, 05:48 PM
I am not making screenshots for something that was mostly painting-in around the lettering by hand. You could do that yourself.
The new size brings new problems. 180x50 px is tiny and if you start with what you have (a poor image) scaling down to that size gives a worse image.
Truthfully, 180x50 is too small for that logo. I can easily show, I re-created the logo using Inkscape a vector application. The vector image ibm-tiny.svg is attached.
Gimp will open it at 180 x 50 and that is about as good as you will get it. If you have lots of these to do, get into using vectors but it is a steep learning curve.
The new size brings new problems. 180x50 px is tiny and if you start with what you have (a poor image) scaling down to that size gives a worse image.
Truthfully, 180x50 is too small for that logo. I can easily show, I re-created the logo using Inkscape a vector application. The vector image ibm-tiny.svg is attached.
Gimp will open it at 180 x 50 and that is about as good as you will get it. If you have lots of these to do, get into using vectors but it is a steep learning curve.