08-18-2020, 09:57 PM
Since the file itself is too large for attachment, I've included it as a Dropbox link below.
In the 'Base Terrain' layer, I need to use the clone tool to fill in the hexside slivers below the full hex depictions. The best way to do this would be to create a mask, that would only allow the clone to paste within the outlines of the hexside slivers. I initially thought that a floating selection could do that, since when I copy the original file into a new layer that does create outlines that do act as masks for the paintbrush tool, but of course, we can't do anything else with a floating selection until it's anchored, at which point the very outlines that I need disappear. Thoughts, suggestions?
https://www.dropbox.com/s/yndmb89mmkvqcn...n.xcf?dl=0
In the 'Base Terrain' layer, I need to use the clone tool to fill in the hexside slivers below the full hex depictions. The best way to do this would be to create a mask, that would only allow the clone to paste within the outlines of the hexside slivers. I initially thought that a floating selection could do that, since when I copy the original file into a new layer that does create outlines that do act as masks for the paintbrush tool, but of course, we can't do anything else with a floating selection until it's anchored, at which point the very outlines that I need disappear. Thoughts, suggestions?
https://www.dropbox.com/s/yndmb89mmkvqcn...n.xcf?dl=0