11-13-2020, 11:33 PM
(This post was last modified: 11-13-2020, 11:35 PM by eepjr24.
Edit Reason: Added system info
)
If I have a selection, for simplicity sake we'll start with a 50 pixel wide line at a 45 degree angle from top left to bottom right. How do I create a path that traverses the approximate center of the selection and is one pixel wide?
I know how to create a selection, shrink a selection, create a path from a selection. But simply shrinking will either end you up with gaps in the path or with areas that are wider than a pixel in the path if there is any deviation in the width. I am fine if this is something I need to do programatically (learning Python, know multiple other languages) if someone can point me in the right direction or the terminology to look for to execute this type of operation. I am no great mathematician, but I can muddle through most geometry and basic trig. And I am fine with putting in time to experiment as necessary.
Edit: Using GIMP 2.10.22 but can upgrade if needed, Win 10 64 bit.
- Ernie
I know how to create a selection, shrink a selection, create a path from a selection. But simply shrinking will either end you up with gaps in the path or with areas that are wider than a pixel in the path if there is any deviation in the width. I am fine if this is something I need to do programatically (learning Python, know multiple other languages) if someone can point me in the right direction or the terminology to look for to execute this type of operation. I am no great mathematician, but I can muddle through most geometry and basic trig. And I am fine with putting in time to experiment as necessary.
Edit: Using GIMP 2.10.22 but can upgrade if needed, Win 10 64 bit.
- Ernie