12-28-2020, 05:15 PM
(12-28-2020, 04:44 PM)rich2005 Wrote: The question might be "which gold part ?"
There are several Gimp tools that will work, some better than others. You could go round the area using the eraser tool, if carefull get what you want. A step up from that is using a layer mask where painting in the layer mask hides the bit you do not want.
or
Selection tools to draw in a boundary around the required part. There is the scissors tool (not so good) or the free select tool (better) then use the selection to either erase the unwanted bit or copy the required part to a new image.
or
For shapes that are essentially straight lines and smooth curves you can use the paths tool. It has some advantages over a direct selection. Goes like this: https://youtu.be/NDgqhIkHN-8 no audio
or
A mixture of all.
It should be the whole gold part that i need, i am going to add photo in the middel