Hi , I am new here.
I have a problem .
I have a service manual that has a total of a 104 pages. (A4, jpg)
One complete section is 8 pages . 4 on the top row and 4 on the bottom row.
to make one complete sheet .
They were scanned and sent to me .
Now to be able to use them I have to stitch them back together it a full large pages .
each Page was scanned as a jpg and they had a very dark back ground that I managed to clean up
using auto Balance .
I have look though the help and could not figure out How to increase the work space to fit four A4 sheets on
top . and Two A4 down . 8 sheets to make one complete image . so I can put this jigsaw back together .
Also some of the pages are not 100% square so the alignment will have to be slid over to match ..
Is this possible .
If so How in the simplest way possible .
O forgot I am using Linux and version 2.10.18
Thanks
I have a problem .
I have a service manual that has a total of a 104 pages. (A4, jpg)
One complete section is 8 pages . 4 on the top row and 4 on the bottom row.
to make one complete sheet .
They were scanned and sent to me .
Now to be able to use them I have to stitch them back together it a full large pages .
each Page was scanned as a jpg and they had a very dark back ground that I managed to clean up
using auto Balance .
I have look though the help and could not figure out How to increase the work space to fit four A4 sheets on
top . and Two A4 down . 8 sheets to make one complete image . so I can put this jigsaw back together .
Also some of the pages are not 100% square so the alignment will have to be slid over to match ..
Is this possible .
If so How in the simplest way possible .
O forgot I am using Linux and version 2.10.18
Thanks