04-21-2021, 11:14 PM
Is it possible to shrink a selection to, for example, 1px width without the selection disappearing in the thinner areas?
Let me give you an example. In the image below, I have selected the "walls" at the edges of this map, shrunk that selection slightly and converted it to a path (in green). The problem is that when I convert it to a path, what I'd like is to instead have a single line through the middle of those walls, instead of two bordering the selection. But if I shrink it too much, some parts of the selection will completely disappear and I think that even if I managed that, the selection to path tool would create two lines anyway bordering the selection.
Perhaps a better question would be, can I create a path from a selection by filling in that selection instead of using the borders for the path?
Thank you!
![[Image: 6sUSXad.png]](https://i.imgur.com/6sUSXad.png)
Let me give you an example. In the image below, I have selected the "walls" at the edges of this map, shrunk that selection slightly and converted it to a path (in green). The problem is that when I convert it to a path, what I'd like is to instead have a single line through the middle of those walls, instead of two bordering the selection. But if I shrink it too much, some parts of the selection will completely disappear and I think that even if I managed that, the selection to path tool would create two lines anyway bordering the selection.
Perhaps a better question would be, can I create a path from a selection by filling in that selection instead of using the borders for the path?
Thank you!