Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Making images with 300 dpi
#7
I do not think you fully understand. The ppi setting controls the size used by the printer. It does not scale anything.

Going back to the LibreCAD export. Make sure the size in pixels is correct so that scaling is not required. Then set the ppi to suit.
Reply


Messages In This Thread
Making images with 300 dpi - by snowforest - 07-27-2021, 08:37 AM
RE: Making images with 300 dpi - by Ofnuts - 07-27-2021, 09:16 AM
RE: Making images with 300 dpi - by rich2005 - 07-27-2021, 09:25 AM
RE: Making images with 300 dpi - by snowforest - 07-27-2021, 11:58 AM
RE: Making images with 300 dpi - by rich2005 - 07-27-2021, 12:43 PM
RE: Making images with 300 dpi - by snowforest - 07-27-2021, 12:56 PM
RE: Making images with 300 dpi - by rich2005 - 07-27-2021, 01:23 PM
RE: Making images with 300 dpi - by snowforest - 07-27-2021, 01:31 PM
RE: Making images with 300 dpi - by rich2005 - 07-27-2021, 01:49 PM
RE: Making images with 300 dpi - by snowforest - 07-27-2021, 02:05 PM
RE: Making images with 300 dpi - by rich2005 - 07-27-2021, 02:24 PM
RE: Making images with 300 dpi - by snowforest - 07-28-2021, 11:37 AM
RE: Making images with 300 dpi - by rich2005 - 07-28-2021, 12:13 PM
RE: Making images with 300 dpi - by snowforest - 07-28-2021, 12:23 PM
RE: Making images with 300 dpi - by rich2005 - 07-28-2021, 12:36 PM
RE: Making images with 300 dpi - by snowforest - 07-28-2021, 12:46 PM

Forum Jump: