07-28-2021, 12:46 PM
(07-28-2021, 12:36 PM)rich2005 Wrote: As long as you are happy with the result, that is all that matters. Hopefully you have learned a little how LibreCAD and Gimp works.
Yes thanks, it was informative and I will refer back to this post land your video later too and I am sure it is informative for others as well. For now, even the size I export from librecad doesnt matter. I simply convert it to 300 dpi first, and then make it smaller, and thats all. I usually make it even smaller when I insert to the book, according to the page layout so the final size is determined inside the book page after I insert the image, which is still smaller than the final size I made, not to loose quaity. So yes always some size is wasted as file size but that is within tolerances. Thanks for the answers.