Hello guys,
I would be grateful if you could clear these two doubts for me:
01- Is there any way to configure the Scale tool so that it accepts values such as W=100%, H=86.602% ?
I have a layer on which I try to apply this transformation, but when I type 86.602, in the Height field, it immediately adjusts to 86.73.
02- When using the Shear tool (shift+H) I can't work with values at angles.
I would like to enter the offset angle of the X Axis, for example, in 30º, but this tool works with "magnitudes", whatever that means.
To get shear to figure at 30º I found an approximate value of magnitude between 98 and 112.
Is there any form/filter/plugin in Gimp that makes it possible to apply shear depending on the desired angle?
Grateful!
I would be grateful if you could clear these two doubts for me:
01- Is there any way to configure the Scale tool so that it accepts values such as W=100%, H=86.602% ?
I have a layer on which I try to apply this transformation, but when I type 86.602, in the Height field, it immediately adjusts to 86.73.
02- When using the Shear tool (shift+H) I can't work with values at angles.
I would like to enter the offset angle of the X Axis, for example, in 30º, but this tool works with "magnitudes", whatever that means.
To get shear to figure at 30º I found an approximate value of magnitude between 98 and 112.
Is there any form/filter/plugin in Gimp that makes it possible to apply shear depending on the desired angle?
Grateful!
.....
Samj Portable - Gimp 2.10.28 - Win-10 /64.
Samj Portable - Gimp 2.10.28 - Win-10 /64.