03-31-2023, 03:51 PM
Thanks so much! This time I just printed the images one at a time onto the same sheet of paper. But next time I'll try to get it right.
I believe my limited knowledge and understanding of ppi is what messed me up. I did make a trimmed canvas for printing my last pedal and reused that and just removed my previous images from it. But when I put my new graphics on that canvas they were wrong size. Looks like my canvas is set to 300 ppi and my graphics are 400 ppi. I increased the value because my understanding was a clearer image even though my last one turned out fine. And pretty much the biggest enclosure I will be using is the same as the pic I posted which is 4.5"x3.5" so perhaps I don't need to worry too much about ppi for that size and smaller and just stick with 300 ppi.
I believe my limited knowledge and understanding of ppi is what messed me up. I did make a trimmed canvas for printing my last pedal and reused that and just removed my previous images from it. But when I put my new graphics on that canvas they were wrong size. Looks like my canvas is set to 300 ppi and my graphics are 400 ppi. I increased the value because my understanding was a clearer image even though my last one turned out fine. And pretty much the biggest enclosure I will be using is the same as the pic I posted which is 4.5"x3.5" so perhaps I don't need to worry too much about ppi for that size and smaller and just stick with 300 ppi.