Oh thanks both !!
I tried by searching with "position" (not that...), "coordinates", "x" / "y", ... and checked all procedure with "get" in it ....
Ok, the key-word is "offset" !!
I see no "*-get-offsets" in the procedures reference ... even though "-layer-set-offsets" exists .......
... but in fact I see a gimp-drawable-offsets notified as "returns the offsets for the drawable" !!
Disturbing in some ways because this name is not consistent with the names used for the other procedures ... in addition there is a gimp-drawable-offset ... which "offset the drawable by the specified amounts in the X and Y directions" ... nonsensical, just with or without "s" ?? it should be "get" and "set" procedures .... but, finally ... if it works it will be ok !
Thanks again !
(Ok, I'm getting a little angry on my own ... I forgot that for width and height it's gimp-drawable-width / -height ... without "-get-" ...
)
I tried by searching with "position" (not that...), "coordinates", "x" / "y", ... and checked all procedure with "get" in it ....
Ok, the key-word is "offset" !!
I see no "*-get-offsets" in the procedures reference ... even though "-layer-set-offsets" exists .......
... but in fact I see a gimp-drawable-offsets notified as "returns the offsets for the drawable" !!
Disturbing in some ways because this name is not consistent with the names used for the other procedures ... in addition there is a gimp-drawable-offset ... which "offset the drawable by the specified amounts in the X and Y directions" ... nonsensical, just with or without "s" ?? it should be "get" and "set" procedures .... but, finally ... if it works it will be ok !
Thanks again !
(Ok, I'm getting a little angry on my own ... I forgot that for width and height it's gimp-drawable-width / -height ... without "-get-" ...
)