Gimp-Forum.net › GIMP › General questions
gimp curve bend

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
gimp curve bend
rita Offline
Junior Gimper
**
Posts: 17
Threads: 5
Joined: Dec 2024
Reputation: 0
Operating system(s):
  • Linux

Gimp version: 2.10
#4
12-12-2024, 06:08 AM
Let's say I want to place an image, like Pikachu, on a cylinder. When I tried, only half of the image was visible. Is there a specific width and height I should use to fit it properly on the cylinder?Or could there be another problem I caused?


Attached Files Thumbnail(s)
       
Find
Reply


Messages In This Thread
gimp curve bend - by rita - 12-11-2024, 12:45 PM
RE: gimp curve bend - by Ofnuts - 12-11-2024, 03:04 PM
RE: gimp curve bend - by rita - 12-12-2024, 07:52 AM
RE: gimp curve bend - by rich2005 - 12-12-2024, 08:19 AM
RE: gimp curve bend - by rita - 12-12-2024, 08:56 AM
RE: gimp curve bend - by rich2005 - 12-12-2024, 09:20 AM
RE: gimp curve bend - by rita - 12-12-2024, 09:24 AM
RE: gimp curve bend - by rich2005 - 12-11-2024, 05:21 PM
RE: gimp curve bend - by rita - 12-12-2024, 06:08 AM
RE: gimp curve bend - by Ofnuts - 12-12-2024, 09:19 AM
RE: gimp curve bend - by denzjos - 12-12-2024, 08:01 AM
RE: gimp curve bend - by rita - 12-12-2024, 08:03 AM

Forum Jump: