01-15-2018, 01:16 PM
(This post was last modified: 01-15-2018, 01:31 PM by Espermaschine.)
Im using the clock method most of the time. Meaning, you create anchor points at the most extreme point, like "top of mountains" and "bottom of valleys" (not sure what the correct term is in english....vertex ?).
You can use this technique in combination with dragging to make a curve or without.
After you set the anchorpoints, you tweak the handles.
Holding down Shift helps keeping the handles on both sides symetric.
Also: handles should follow the direction of the line for a bit.
To avoid bumps, make sure the handles on both sides maintain a straight line, otherwise you will get a corner.
You can use this technique in combination with dragging to make a curve or without.
After you set the anchorpoints, you tweak the handles.
Holding down Shift helps keeping the handles on both sides symetric.
Also: handles should follow the direction of the line for a bit.
To avoid bumps, make sure the handles on both sides maintain a straight line, otherwise you will get a corner.