05-10-2018, 08:44 PM
I installed Gimp 2.10, but when I tried to run it, I got error messages for procedure entry points could not be found. Some of them were from GMIC. One of them is from Twain.exe.
I uninstalled GMIC, then uninstalled Gimp, then reinstalled Gimp, but I still got the same error messages.
I then re-installed GMIC, but I still got the same error message.
Could someone tell me how to install Gimp 2.10 fresh? Forget about GMIC now. I can re-install it later. But for now, I just want to install Gimp 2.10 without those error messages. Thanks in advance!
I uninstalled GMIC, then uninstalled Gimp, then reinstalled Gimp, but I still got the same error messages.
I then re-installed GMIC, but I still got the same error message.
Could someone tell me how to install Gimp 2.10 fresh? Forget about GMIC now. I can re-install it later. But for now, I just want to install Gimp 2.10 without those error messages. Thanks in advance!