(02-23-2017, 03:21 AM)Fleetwin Wrote: I'm trying to make a new decal from my vintage outboard. I'm using Gimp 2.8.
It's almost good enough (for me) but I'm having trouble getting the bottom border
radius' looking natural like the top corners, but otherwise, I have it shaped like
the original. Help or suggestions appreciated, Thanks!
P.S.- My off white "background" make it hard to even distinguish the
border on this forum. ..... not sure what I can do so you can see
the problem better.
Something like this one?
If the one shown above is what you need I did the following:
1) taken your image
2) added two transparent layers below your image
3) filled the whole middle layer with the "fake" white BG colour of your image
4) rounded rectangle selection on the middle layer with a radius to cope with your upper shape
5) invert selection, cut
6) merged down