09-03-2023, 10:54 PM
A simple technique to make a path follow a given curve:
Make a path that is a straight line between two points o the curve.
Eyeball where a tangent to the curve is roughly parallel to the path line (around the middle for a regular curve). Click on the corresponding point on the line, and control-click on the line to add an anchor,
Drag the anchor to the curve. Your path should be a line that is pretty close to the curve.
If it is not close enough, repeat the process for the parts that require it
Make a path that is a straight line between two points o the curve.
Eyeball where a tangent to the curve is roughly parallel to the path line (around the middle for a regular curve). Click on the corresponding point on the line, and control-click on the line to add an anchor,
Drag the anchor to the curve. Your path should be a line that is pretty close to the curve.
If it is not close enough, repeat the process for the parts that require it
Very often a single midpoint is sufficient, for instance the top of the wing is an easy fit: